Loading...

Selleys No More Gaps

No More Gaps is a durable, flexible acrylic gap sealant for interior and exterior applications where joint movement causes rigid fillers to crack or fall out.

 

Features 

  • Superior flexibility to cope with building movement, meaning the cracks and gaps will be hidden for longer.
  • Has greater than 300% elongation/stretch and up to +/- 15% movement capability.
  • Superior adhesion to a broad range of surfaces, resulting in a lasting finish.
  • A smooth flawless finish and minimal shrinkage.
  • Can be painted over with both water and oil based paints, after the surface has skinned (approximately 30 minutes* after application).
  • Is formulated for long term resistance to cracking and crumbling.
  • Easy water clean-up
  • Will not stain building materials.
  • Has good resistance to weathering.
  • Low toxic, low odour, low VOC, less harmful to the environment

Ideal For 

  • Ceramic, concrete and wood

Buy Now

Selleys No More Gaps
Buy Now
Categories: ,
Size 320g Tube, 380g Cartridge
Colour White
Full Cure Time Skins in 20 minutes, Paintable after 1 hour. Ideally left to dry for at least 8 hours.
Technology Water Based
Use Exterior, Interior

Where can this product be used?

No More Gaps may be used for sealing gaps and joints where slight movement is anticipated (less than +/- 10% of joint width)

  • Between window or door frames and the wall
  • Along skirting boards and around cornices
  • Between bench tops and tiles
  • In corners or between the wall and ceiling or anywhere shrinkage or movement has caused rigid filler to crack

What materials is this product suitable for?

  • Brick
  • Concrete
  • Timber
  • Fibre cement sheeting
  • Hardboards
  • Laminated plastics
  • Ceramics
  • Aluminium
  • Painted surface

How to Use

 

  1. Ensure surfaces are clean.
  2. Apply a layer of masking tape along the perimeter line where Selleys No More Gaps are to be applied.
  3. Cut cartridge tip with a knife or blade and insert into caulking gun.
  4. Attach nozzle on cartridge and cut the nozzle tip at 45 degree angle.
  5. Apply on needed surface and, smoothen with a scraper or spatula.
  6. Once applied, peel of the masking taped along the perimeters for a clean finishing & leave the sealant to dry for at least 6-8 hours.

Limitations:

  • Maximum gap size recommended – width 25mm, depth 12mm.
  • No More Gaps is not recommended where significant joint movement occurs, such as gaps between tongue and groove boards or weatherboard overlaps.
  • Not suitable for sealing around bathtubs, kitchen sinks and in shower recesses.
  • Not suitable for areas of continuous water immersion or in constantly damp areas.
  • No More Gaps should not be applied at temperatures below 5oC.
  • No More Gaps is not suitable in those applications where joint movement is in excess of +/- 10% of joint width.

Handy Tips

  • No More Gaps will skin after approx 30 minutes and it cures within 24 hours to a durable, flexible seal.
  • Allow for longer skin and cure times under cold/damp conditions.
  • Product should be protected from rain until firmly skinned.

Clean Up

  • Any excess caulk should be cleaned up with water (a damp cloth) immediately after application.
  • Cured caulk will need to be cut away. Remaining caulk can be softened with acetone and then removed.

Data Sheet

SDS – No More Gaps White

TDS-No More Gaps